Deposition kinetics of MS2 bacteriophages on clay mineral surfaces

The deposition of bacteriophage MS2 on bare and clay-coated silica surfaces was examined in both monovalent (NaCl) and divalent (CaCl2 and MgCl2) solutions under a wide range of environmentally relevant ionic strength and pH conditions by utilizing a quartz crystal microbalance with dissipation (QCM-D). Two types of clay, bentonite and kaolinite, were concerned in this study. To better understand MS2 deposition mechanisms, QCM-D data were complemented by zeta potentials measurements and Derjaguin–Landau–Verwey–Overbeek (DLVO) interaction forces calculation. In both monovalent and divalent solutions, deposition efficiencies of MS2 increased with increasing ionic strength both on bare and clay-coated surfaces, which agreed with the trends of interaction forces between MS2 and solid surface and thus was consistent with DLVO theory. The presence of divalent ions (Ca2+ and Mg2+) in solutions greatly increased virus deposition on both silica and clay deposited surfaces. Coating silica surfaces with clay minerals, either kaolinite or bentonite, could significantly increase MS2 deposition.

. Coating silica surfaces with clay minerals, either kaolinite or bentonite, could significantly increase MS2 deposition.Figure optionsDownload as PowerPoint slideHighlights
► Solution chemistry affects MS2 deposition on silica and clay-coated surfaces.
► Deposition of MS2 on silica and clay-coated surfaces is controlled by DLVO forces.
► Presence of divalent ions (Ca2+ and Mg2+) in solutions increases MS2 deposition.
► Coating silica surfaces with clay minerals increases MS2 deposition.