کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
616315 | 881485 | 2009 | 7 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Mechanical and tribological properties of Al–40Zn–Cu alloys Mechanical and tribological properties of Al–40Zn–Cu alloys](/preview/png/616315.png)
One binary Al–40Zn and five ternary Al–40Zn–Cu alloys with different copper contents were prepared by permanent mould casting. Their microstructure and mechanical properties were investigated in as-cast state. Friction and wear properties of the ternary alloys were studied using a conforming block-on-disc type tester. The results obtained were compared with those of SAE 65 bearing bronze.The microstructure of Al–40Zn–Cu alloys consisted of aluminium-rich α dendrites surrounded by eutectoid α+η phases and θ (CuAl2) particles. Hardness of the ternary alloys increased continuously with increasing copper content, but their tensile strength decreased above 3% Cu. Friction coefficient and temperature of the Al–40Zn–Cu alloys and bronze increased in the initial period of run. This was followed by a reduction in the properties and attainment of constant levels afterwards. However, volume loss of the alloys increased rapidly at the beginning of the test run and reached almost constant levels after a sliding distance of approximately 400 km. The Al–40Zn–Cu alloys were found to be much superior to the SAE 65 bronze, as far as their wear resistance is concerned. Among the alloys tested, highest strength and wear resistance were obtained with the Al–40Zn–3Cu alloy.
Journal: Tribology International - Volume 42, Issue 1, January 2009, Pages 176–182