Cleaning of viscous drops on a flat inclined surface using gravity-driven film flows

We investigate the fluid mechanics of cleaning viscous drops attached to a flat inclined surface using thin gravity-driven film flows. We focus on the case where the drop cannot be detached either partially or completely from the surface by the mechanical forces exerted by the cleaning fluid on the drop surface. Instead a convective mass transfer establishes across the drop-film interface and the fluid in the drop dissolves into the cleaning film flow, which then transports it away. The characteristic time scale of dissolution is much longer than the advection time scale in the film flow. Thus, the shape and size of the drop can be considered as quasi-steady. To assess the impact of the shape and size of the drop on the velocity of the cleaning fluid, we have developed a novel experimental technique based on particle image velocimetry. We show the velocity distribution at the film surface in the situations both where the film is flowing over a smooth surface, and where it is perturbed by a solid obstacle representing a very viscous drop. We find that at intermediate Reynolds numbers the acceleration of the starting film is overestimated by a plane model using the lubrication approximation. In the perturbed case, the streamwise velocity is strongly affected by the presence of the obstacle. The upstream propagation of the disturbance is limited, but the disturbance extends downstream for distances larger than 10 obstacle diameters. Laterally, we observe small disturbances in both the streamwise and lateral velocities, owing to stationary capillary waves. The flow also exhibits a complex three-dimensional converging pattern immediately below the obstacle.