An experimental investigation on heat transfer characteristics of multi-walled CNT-heat transfer oil nanofluid flow inside flattened tubes under uniform wall temperature condition

An experimental investigation on heat transfer characteristics of MWCNT-heat transfer oil nanofluid flow inside horizontal flattened tubes has been carried out under uniform wall temperature condition. Nanoparticle weight fractions were 0%, 0.1%, 0.2%, and 0.4%. The copper tubes of 14.5 mm I.D. were flattened and used as the test section of oblong shape with inside heights of 13.4 mm, 11.7 mm, 10.6 mm, and 8.6 mm. The nanofluid flowing inside the tube was heated inside a steam chamber to keep the temperature of the tube wall constant. The required data were acquired for laminar hydrodynamically fully developed regime. The effects of different parameters such as volumetric flow rate, nanoparticle weight fraction, and hydraulic diameter on the heat transfer behavior of the tested systems have been investigated experimentally. For a given flattened tube at a constant nanoparticle weight fraction, increasing volumetric flow rate results in heat transfer enhancement. In addition, as the tube profile becomes more flattened and the hydraulic diameter decreases, the heat transfer coefficient goes up at constant volumetric flow rate. Utilizing nanofluids instead of the base fluid, the heat transfer rate enhances remarkably. The higher the nanoparticles weight fraction, the more the rate of heat transfer enhancement. Finally, the results show that the amount of increase in heat transfer coefficient caused by employing nanofluid instead of the base fluid is comparable to what caused by flattening the tube.