Combustion of agricultural residues: An experimental study for small-scale applications

Energy services could be greatly improved by using of residues from local food industries in small-scale combustion units. Wood pellets are a reliant and proven fuel to be used in small-scale combustion units. However, these units should preferably be able to use different types of biomass depending what it is locally available. Therefore, studies have been focused on exploring the suitability of using agricultural residues for small-scale heat and power generation using direct combustion. This study targets to compare the combustion of different agricultural residues in a single unit designed for wood pellets. The different biomass fuels used are Ø6 mm and Ø8 mm wood pellets, Ø6 mm bagasse pellets, Ø6 mm sunflower husk (SFH) pellets and Brazil nut (BN) shells. The results reveal a decrease in the fuel power input, higher oxygen levels in the flue gases and shorter cycles for ash removal when using the agricultural residues. The excess air ratio was calculated based on a mass balance and compared with a standard equation showing a good agreement. CO and NO emission levels as well as the relative conversion of fuel-C to CO were higher for the BN shells and SFH pellets in comparison to the other biomass types. SO2 emission was estimated based on the analysis of unburned sulfur in ash and mass balances; the higher estimated levels corresponded to the BN shells and SFH pellets. All the biomass sorts presented over 95% relative conversion of fuel-C to CO2. Wood pellets and BN shells presented the highest amount of unburned carbon in ash relative to the fuel-C. The relative conversion of fuel-N to NO and fuel-S to SO2 were higher for wood pellets. Bagasse pellets showed similar emission levels and relative conversion efficiency to wood pellets.