Study on structural failure of RPV with geometric discontinuity under severe accident

A severe accident management strategy known as 'in-vessel retention (IVR)' is widely adopted in most of advanced nuclear power plants. The IVR mitigation is assumed to be able to arrest the degraded melting core and maintain the structural integrity of reactor pressure vessel (RPV) within a prescribed period of time. This traditional concept of IVR without consideration of internal pressure effect wasn't challenged until the occurrence of Fukushima accident on 2011, which showed that the structural behavior had not been appropriately assessed, and a certain pressure (up to 8.0 MPa) still existed inside the RPV. Accordingly, the paper tries to address the related issue on whether lower head (LH) integrity can be maintained, when the LH is subjected to the thermal-mechanical loads created during such a severe accident. Because of the presence of the high temperature melt (∼1300 °C) on the inside of RPV, some local material is melted down to create a unique RPV with geometric discontinuity, while the outside of RPV submerged in cavity water will remain in nucleate boiling (at ∼150 °C). Therefore, the failure mechanisms of RPV can span a wide range of structural behaviors, such as melt-through, creep damage, plastic yielding as well as thermal expansion. Through meticulous investigation, it is found that the RPV failure is mainly caused by creep and plasticity, especially for the inside of highly-eroded region. The elastic core (or layer) is found to exist in the proximity of mid-section of the highly-eroded wall. However, the elastic core is squeezed into a smaller size with the internal pressure increase. Besides, the multiaxial state of stress is found to accelerate the damage evolution on the thinnest site.