Polyethylene/polyurethane blends for improved paint adhesion

Polyolefins have low free surface energy that prevents good wettability of adhesives or paint emulsions to their surface. This work shows that adhesion of olefin block copolymers (OBC) to a polyurethane-based paint can be significantly improved by blending thermoplastic polyurethane (TPU) into OBC. Furthermore, blend morphologies near the paint/polymer interface, and surface compositions of injection molded plaques, were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and Fourier-transform infrared spectroscopy with attenuated total reflectance (FTIR-ATR) in order to explore the underlying mechanism of paint adhesion to TPU/OBC blends. It was found that for 35 wt% and 25 wt% TPU loading, the top paint layer is well-attached at the interface, whereas for 15 wt% loading, there was incomplete wetting of the paint, and a gap between the polymer substrate and paint was apparent. XPS and SEM gave consistent results demonstrating that outermost surface composition of TPU in these blends is slightly higher than in the bulk. It is speculated here that, during painting and the subsequent drying step, polyurethane chains from the paint diffuse into the blend substrate and entangle with TPU in the blend. The entanglement between paint and substrate generates a physical link that provides adhesion.

• Adhesion of polyolefin to paint is significantly improved by blending polyurethane.
• Outermost surface of injection molded blends is determined to have more TPU.
• Composition of blends at 5 μm below surface is determined to be the same as bulk.
• SEM and AFM gave evidence on inter-diffusion between paint and substrate.
• Polymer inter-diffusion is proposed as paint adhesion mechanism.