Tribological properties and cutting performance of boron and silicon doped diamond films on Co-cemented tungsten carbide inserts

Boron and silicon doped diamond films are deposited on the cobalt cemented tungsten carbide (WC-Co) substrate by using a bias-enhanced hot filament chemical vapor deposition (HFCVD) apparatus. Acetone, hydrogen gas, trimethyl borate (C3H9BO3) and tetraethoxysilane (C8H20O4Si) are used as source materials. The tribological properties of boron-doped (B-doped), silicon-doped (Si-doped) diamond films are examined by using a ball-on-plate type rotating tribometer with silicon nitride ceramic as the counterpart in ambient air. To evaluate the cutting performance, comparative cutting tests are conducted using as-received WC-Co, undoped and doped diamond coated inserts, with high silicon aluminum alloy materials as the workpiece. Friction tests suggest that the Si-doped diamond films present the lowest friction coefficient and wear rate among all tested diamond films because of its diamond grain refinement effect. The B-doped diamond films exhibit a larger grain size and a rougher surface but a lower friction coefficient than that of undoped ones. The average friction coefficient of Si-doped, B-doped and undoped diamond films in stable regime is 0.143, 0.193 and 0.233, respectively. The cutting results demonstrate that boron doping can improve the wear resistance of diamond films and the adhesive strength of diamond films to the substrates. Si-doped diamond coated inserts show relatively poor cutting performance than undoped ones due to its thinner film thickness. B-doped and Si-doped diamond films may have tremendous potential for mechanical application.

► Mechanical properties of undoped, B-doped and Si-doped diamond films are studied.
► Silicon doping can refine the diamond grain.
► Lowest COF and wear rate for Si-doped diamond films are obtained.
► B-doped diamond films show rougher surface but lower COF than that of undoped ones.
► B-doped diamond films present excellent cutting performance in cutting Al–Si alloy.