Effect of tool axis offset and geometry of tool pin profile on the characteristics of friction stir welded dissimilar joints of aluminum alloy AA5052 and HSLA steel

In the present work, the effect of tool axis offset from the joint interface and geometry of the FSW tool pin on the mechanical and metallographic characteristics of dissimilar friction stir butt welded aluminum (Al) alloy, AA5052 H32 and HSLA steel, IRSM42-93 were investigated. FSW tools having fixed shoulder diameter, pin tip diameter and pin length with three different tapered cylindrical (TC) and one straight cylindrical (SC) tool pin profiles were experimented. The constant FSW parameters used were: tool rotational speed of 500 rpm, welding speed of 45 mm/min, axial load of 7 kN and tool tilt angle of 1.5°. The effect of tool axis offset was investigated by continuously changing the tool axis offset by keeping the tool traverse direction at an angle to the joint interface. The ultimate tensile strength (UTS) of the joint is considered as the main criterion of the joint performance. The results show that the TC pin profile is beneficial and for a given FSW tool geometry and parameters, the taper angle of the tool pin and volume of tool pin penetration into steel side have significant influence on the thickness and composition of the intermetallic compound (IMC) layer formed and hence the joint performance. FSW tool having TC pin with 10° taper angle has produced the best joint at a tool axis offset of 2 mm towards the Al alloy. For the experimented tool pin geometries, the IMC layer formed at the joint interface is consistent with FeAl, Fe2Al5 and FeAl3.