Deformation micromechanics of a model cellulose/glass fibre hybrid composite

Interfacial stress transfer in a model hybrid composite has been investigated. An Sm3+ doped glass fibre and a high-modulus regenerated cellulose fibre were embedded in close proximity to each other in an epoxy resin matrix dumbbell-shaped model composite. This model composite was then deformed until the glass fibre fragmented. Shifts of the absolute positions of a Raman band from the cellulose fibre, located at 1095 cm−1, and a luminescence band from a doped glass fibre, located at 648 nm, were recorded simultaneously. A calibration of these shifts, for both fibres deformed in air, was used to determine the point-to-point distribution of strain in the fibres around the breaks in the glass fibre. Each break that occurred in the glass fibre during fragmentation was shown to generate a local stress concentration in the cellulose fibre, which was quantified using Raman spectroscopy. Using theoretical model fits to the data it is shown that the interfacial shear stress between both fibres and the resin can be determined. A stress concentration factor (SCF) was also determined for the regenerated cellulose fibre, showing how the presence of debonding reduces this factor. This study offers a new approach for following the micromechanics of the interfaces within hybrid composite materials, in particular where plant fibres are used to replace glass fibres.