Treatment of WEEE industrial wastewaters: Removal of yttrium and zinc by means of micellar enhanced ultra filtration

In this paper, the efficiency of micellar enhanced ultrafiltration technique (MEUF) was tested for the removal of yttrium and zinc ions from synthetic industrial liquid wastes. UF membranes (monotubular ceramic membranes of 210 kDa and 1 kDa molecular weight cut-off) were used with adding an anionic surfactant, sodium dodecyl sulfate (SDS). A two - level full factorial design was performed in order to evaluate the effect of molecular weight cut-off, sodium dodecyl sulfate concentration and pressure on the permeate flux and rejection yields. It was found that the single factors presented the largest influence on the permeate flux: the membrane pore size and the pressure had positive effect, instead the SDS had negative effect. Regarding the metal rejection yields the main relevant factors were the membrane pore size with a negative effect, followed by the surfactant concentration with a positive effect. The effect of the pressure seemed to be almost negligible, for zinc removal experiments had a positive effect in the interactions with the surfactant and membrane pore size. The results showed that very good removal percentages up to 99% were achieved for both metals under the following conditions: 1 kDa membrane MWCO, in the presence of the surfactant at a concentration above CMC independently of the investigated pressure.