A study of crack growth retardation due to artificially induced crack surface contact

The contact of the cracked surfaces during a part of a loading cycle generally results in a reduced crack growth rate. A critical experiment was designed to evaluate the influence of the crack surface contact on crack growth. A round compact specimen made of 1070 steel with a round hole at the wake of the fatigue crack was designed. Two mating wedges were inserted into the hole of the specimen while the external load was kept at its maximum in a loading cycle. In this way, the wedges and the hole in the specimen were in firm contact during the entire loading cycle in the subsequent loading. Experiments showed that the addition of the wedges resulted in a reduction of crack growth rate in the subsequent constant amplitude loading. However, crack growth did not arrest. With the increase in the subsequent loading cycles, crack growth rate increased. The traditional crack closure concept cannot explain the experimental phenomenon because the effective stress intensity factor range was zero after the insertion of the wedges. The detailed stress-strain responses of the material near the crack tip were analyzed by using the finite element method with the implementation of a robust cyclic plasticity theory. A multiaxial fatigue criterion was used to determine the fatigue damage based upon the detailed stresses and strains. The crack growth was simulated and the predicted results were in good agreement with the experimental observations. It was confirmed that the stresses and strains near the crack tip governed cracking behavior. Crack surface contact reduced the crack tip cyclic plasticity and the result was the observed retardation in crack growth.