Early detection and monitoring of fatigue in high strength steels with MWM-Arrays

Fatigue monitoring of cyclically loaded shot peened high-strength steel components can be accomplished via magnetic permeability measurements during laboratory tests or in service. These measurements can be performed either continuously using permanently mounted Meandering Winding Magnetometer Arrays (MWM®-Arrays) or intermittently with scanning MWM-Arrays. The results obtained to date suggest that MWM-Array permeability measurements can provide early detection of fatigue damage in steels before conventional methods can detect any changes. This has been demonstrated to be particularly significant in the presence of high compressive stresses introduced by shot peening. One of the fatigue tests was suspended when accelerating changes in local permeability were detected. Examination of the fatigue specimen in a scanning electron microscope detected only a few relatively small cracks, e.g. 50-200 μm long at the surface. Fractography, however, revealed significantly longer cracks. For the same specimen, conventional eddy current and ultrasonic testing failed to provide any indications of cracks, and fluorescent liquid penetrant detected only an inconclusive spot indication. This paper provides a comparison of the permeability changes and fractography data with a fatigue crack growth curve based on a FASTRAN analysis accounting for residual stresses from shot peening. A comparison of the experimental data and crack growth analysis results suggested that MWM-Array magnetic permeability measurements may detect cracks in the compressive stress field when they are about 50 μm deep.