کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
9796358 | 1514945 | 2005 | 9 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Surface roughness of microstructured component fabricated by μMIM
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی مواد
دانش مواد (عمومی)
پیش نمایش صفحه اول مقاله
چکیده انگلیسی
Micro metal injection moulding (μMIM) is being developed for possible mass production of metallic microstructured components. In the micrometer regime, consideration of surface roughness becomes more important as dimensional tolerance is towards the range of surface roughness and surface force becomes dominant at the surface-to-volume ratio encountered. In this paper, the effects of sintering temperature and time on surface roughness (Ra) and surface grain size (G) of 316L stainless steel microstructured components fabricated by μMIM were investigated. In particular, the top surface of the microstructure and the substructure area, on which the microstructures were positioned, were characterised. After sintering, Ra values at these areas were similar even though disparate magnitudes were measured in the mould insert and the moulded microstructured component. Ra and G were found to increase with sintering temperature for the top surface of the microstructure. A smaller G tended to yield lower Ra and the substructure had smaller grain size and lower Ra value than the comparatively free-standing microstructures.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Materials Science and Engineering: A - Volume 396, Issues 1â2, 15 April 2005, Pages 311-319
Journal: Materials Science and Engineering: A - Volume 396, Issues 1â2, 15 April 2005, Pages 311-319
نویسندگان
B.Y. Tay, L. Liu, N.H. Loh, S.B. Tor, Y. Murakoshi, R. Maeda,