Keywords: ULSD; Deep HDS; Nitrogen compounds; Inhibition effect; Diesel; HDT;
مقالات ISI (ترجمه نشده)
مقالات زیر هنوز به فارسی ترجمه نشده اند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
در صورتی که به ترجمه آماده هر یک از مقالات زیر نیاز داشته باشید، می توانید سفارش دهید تا مترجمان با تجربه این مجموعه در اسرع وقت آن را برای شما ترجمه نمایند.
Keywords: ACA; Apparent Contact Angle; PP; Polypropylene; PG; Propylene Glycol; SE; Surface Evolver; ULSD; Ultra Low Sulfur Diesel; YLCA; Young-Laplace Contact Angle; Droplet-fiber interactions; Droplet shape modeling; Surface roughness; Droplet contact angle;
Keywords: NVH; Biodiesel blends; Diesel engine; Combustion; Noise; Vibration; deg CA; crank angle degree; NI; noise index; NVH; noise vibration harshness; RMS; root mean square; STFT; short time Fourier transform; UCO; used cooking oil; ULSD; ultra-low sulfur diese
Keywords: ULSD; Sulfur content; Storage; High-throughput sequencing analysis; Microbial community;
Keywords: High sulfur diesel fuel; Diesel oxidation catalyst; Catalyst sulfur poisoning; Catalyst light-off; BMEP; Brake Mean Effective Pressure; DECSE; Diesel Emission Control-Sulfur Effects; DOC; Diesel Oxidation Catalyst; DPF; Diesel Particulate Filter; FTP; F
Keywords: AHRR; apparent heat release rate; ATDC; after top dead center; CA; crank angle; CA10; crank angle of 10% mass fraction burned; CA50; crank angle of 50% mass fraction burned; CN; cetane number; DI; direct injected; DOI; duration of injection; EER; effectiv
Keywords: PTF; Plastic-to-fuel; NRP; Non-recycled plastics; ULSD; Ultra-low sulfur diesel; GREET; Regulated Emissions and Energy use in Transportation; GHG; Greenhouse gas; LCA; Life-cycle analysis; WTE; Waste-to-energy; MSW; Municipal solid waste; MRF; Material re
Keywords: ATDC; after top dead center; CA; crank angle; CA10; crank angle of 10% mass fraction burned; CA50; crank angle of 50% mass fraction burned; CN; cetane number; DI; direct injected; DISOI; direct injection start of injection; DOI; duration of injection; EGR
Keywords: A/F; air to fuel ratio; ASTM; American Society for Testing and Materials; BMEP; Brake Mean Effective Pressure; BSCO; brake specific CO; BSFC; brake specific fuel consumption; BSHC; brake specific HC; BSNOx; brake specific NOx; BTDC; Before Top Dead Center
Keywords: AOCS; American Oil Chemists' Society; ASTM; American Society for Testing and Materials; AV; acid value; CEN; European Committee for Standardization; CFPP; cold filter plugging point; CME; canola oil methyl esters; CP; cloud point; FA; fatty acid; FAME;
Keywords: ASTM; American Society for Testing and Materials; US EPA; United States Environment Protect Agency; GC; gas chromatograph; FID; flame ionization detector; LHV; lower heating value (kJ/kg); ppm; parts per million; rpm; revolution per minute; CO; carbon mon
Keywords: RME; GTL; ULSD; GCMS; XRD; SEM/EDS;
Keywords: ASTM; American Society of Testing and Materials; EPA; Environmental Protection Agency; ULSD; Ultra Low Sulfur Diesel; HiTOM; High Temperature Oscillating Machine; BOCLE; Ball On Cylinder Lubricity Evaluator; HFRR; High Frequency Reciprocating Rig; S BOCLE
Keywords: ATDC; after top dead center; CAD; crank angle degree; EGR; exhaust gas recirculation; HC; hydrocarbons; NOx; oxides of nitrogen; PM; particulate matter; SOF; soluble organic fraction; ULSD; ultra low sulfur diesel fuel; EGR coolers; Fouling; Diesel engine
Keywords: AFT; adiabatic flame temperature; ANOVA; analysis of variance; BM (β); isentropic bulk modulus; c; speed of sound; CAD; crank angle degree; CN; cetane number; CO; carbon monoxide; CO2; carbon dioxide; COV; coefficient of variation; ELPI; electronic low p
Experimental investigation of physicochemical properties of diesel, biodiesel and TBK-biodiesel fuels and combustion and emission analysis in CI internal combustion engine
Keywords: Triglycerides Of Modified Structures; TBK-Biodiesel; Physicochemical properties; Combustion analysis; Emission analysis; CI engine; Compression Ignition engine; TBK; the first character of the surnames of the three inventors (Thész, Boros, Király) of th
Pilot plant experimentation to optimize the use of re-generated CoMo catalyst to process atmospheric and vacuum gas oil
Keywords: Vacuum gas oil; ULSD; HDT; H2 content; Catalyst deactivation; HDT pilot plant test;
Extraction and characterization of waste plastic oil (WPO) with the effect of n-butanol addition on the performance and emissions of a DI diesel engine fueled with WPO/diesel blends
Keywords: a(b)BDC; after (before) bottom dead centre; a(b)TDC; after (before) top dead centre; CAS; chemical abstract service; CO; carbon monoxide; DI; direct injection; D50-WPO40-B10; 50% ULSD 40% waste plastic oil 10% n-butanol blend by vol.; D50-WPO30-B20; 50% U
Review on the management of RCCI engines
Keywords: ATDC; after top dead center; BMEP; brake mean effective pressure; CA50; crank angle of 50% heat released; CA; crank angle; CDC; conventional diesel combustion; CI; compression ignition; CO; carbon monoxide; CRI; common rail injector; DDFS; direct dual fue
Comparison of the metal-organic framework MIL-101 (Cr) versus four commercial adsorbents for nitrogen compounds removal in diesel feedstocks
Keywords: Adsorption; Nitrogen-compounds; MIL-101 (Cr); SRGO; LCO; ULSD;
Fuel properties of Brassica juncea oil methyl esters blended with ultra-low sulfur diesel fuel
Keywords: Biodiesel; Blends; Brassica juncea; Diesel; Fatty acid methyl esters; Properties; AV; acid value; BJME; B. juncea oil methyl esters; BJO; B. juncea oil; CFPP; cold filter plugging point; CP; cloud point; DCN; derived cetane number; FA; fatty acid; FFA;
Thermodynamics of semicontinuous n-alcohol/ultra-low sulfur diesel blends
Keywords: ULSD; alcohols; UNIFAC; Continuous thermodynamics; Phase equilibrium; Activity coefficients
The effects of hydrogen on the efficiency of NOx reduction via hydrocarbon-selective catalytic reduction (HC-SCR) at low temperature using various reductants
Keywords: Hydrocarbon selective catalytic reduction; Hydrogen addition; Low temperature; NOx; C3H6, C7H16, C12H26, diesel fuel; HC-SCR; hydrocarbon selective catalytic reduction; NOx; nitrogen oxide; NO; nitric oxide; NO2; nitrogen dioxide; CO2; carbon dioxide; THC
A pilot reactor study to determine operational factors of the commercial hydrodesulphurization (HDS) catalyst to produce ultra-low sulphur diesel (ULSD)
Keywords: Light Gas Oil; ULSD; H2 consumption; Catalyst deactivation; HDT pilot plant test
Experimental study of the spray characteristics of USLD, methanol and DME on the swirl nozzle of a Stirling engine
Keywords: Stirling engine; Methanol; DME; ULSD; Spray characteristics; Size distribution characteristics
Denitrogenation of middle distillates using adsorbent materials towards ULSD production: A review
Keywords: Nitrogen; Adsorption; Adsorbents; ULSD; Middle distillates
Efficacy of specific gravity as a tool for prediction of biodiesel-petroleum diesel blend ratio
Keywords: APE; average percent error; AV; acid value; CFME; chicken fat methyl esters; CP; cloud point; FA; fatty acid; FAME; fatty acid methyl ester; HDS; hydrodesulfurization; KV; kinematic viscosity; LSD; low-sulfur (<500Â ppm) diesel fuel; PME; palm oil methyl
High speed imaging of OH* chemiluminescence and natural luminosity of low temperature diesel spray combustion
Keywords: AHRR; apparent heat release rate; ASOI; after the start of injection; CHR; cumulative heat release; CI; compression ignition; Eff. Gain; effective gain; EGR; exhaust gas recirculation; FWHW; full width half maximum; HCCI; homogeneous charge compression ig
Speciation of particulate matter and hydrocarbon emissions from biodiesel combustion and its reduction by aftertreatment
Keywords: Biodiesel; Particulate matter; Combustion; Emissions; BSN; bosch smoke number; CAD; crank angle degree; CO; carbon monoxide; CO2; carbon dioxide; COV; coefficient of variation; DOC; diesel oxidation catalyst; DPF; diesel particulate filter; DTA; different
Enhancing the lubricity of an environmentally friendly Swedish diesel fuel MK1
Keywords: Lubricity; MK1; ULSD; Fatty acid methyl esters; Biodiesel; HFRR
Effect of ethyleneglycol addition on the properties of P-doped NiMo/Al2O3 HDS catalysts: Part I. Materials preparation and characterization
Keywords: Ethyleneglycol; Phosphomolybdates; Hydrodesulfurization; NiMo/Al2O3 catalyst; NiMoS phase; ULSD
Trickle bed reactor model to simulate the performance of commercial diesel hydrotreating unit
Keywords: ULSD; Vaporization; Modeling
Development of ultra-deep HDS catalyst for production of clean diesel fuels
Keywords: Hydrodesulfurization; Ultra-deep HDS; Ultra-low sulfur; Cobalt molybdenum catalyst; Co–Mo–S phase; ULSD
The role of reaction pathways and support interactions in the development of high activity hydrotreating catalysts
Keywords: Hydrodesulfurization; STM; DFT; HAADF-STEM; ULSD; Support interaction; Hydrogenation; Active sites; MoS2; Nanoclusters; Thiophene; CoMo catalysts; Type II CoMoS; Brim sites;