Lysine-poly(2-hydroxyethyl methacrylate) modified polyurethane surface with high lysine density and fibrinolytic activity

We have developed a potentially fibrinolytic surface in which a bioinert polymer is used as a spacer to immobilize lysine such that the ε-amino group is free to capture plasminogen when in contact with blood. Adsorbed plasminogen can be activated to plasmin and potentially dissolve nascent clots formed on the surface. In previous work lysine was immobilized through a poly(ethylene glycol) (PEG) spacer; however, the graft density of PEG was limited and the resulting adsorbed quantity of plasminogen was insufficient to dissolve clots efficiently. The aim of the present work was to optimize the surface using graft-polymerized poly(2-hydroxyethyl methacrylate) (poly(HEMA)) as a spacer to increase the grafting density of lysine. Such a poly(HEMA)-lysine modified polyurethane (PU) surface is expected to have increased plasminogen binding capacity and clot lysing efficiency compared with PEG-lysine modified PU. A lysine density of 2.81 nmol cm−2 was measured on the PU-poly(HEMA)-Lys surface vs. 0.76 nmol cm−2 on a comparable PU-PEG-Lys surface reported previously. The poly(HEMA)-lysine-modified surface was shown to reduce non-specific (fibrinogen) adsorption while binding plasminogen from plasma with high affinity. With increased plasminogen binding capacity these surfaces showed more rapid clot lysis (20 min) in a standard in vitro assay than the corresponding PEG-lysine system (40 min). The data suggest that poly(HEMA) is superior to PEG when used as a spacer in the immobilization of bioactive molecules at high density. This method of modification may also provide a generic approach for preparing bioactive PU surfaces of high activity and low non-specific adsorption of proteins.