A fully automated plasma protein precipitation sample preparation method for LC–MS/MS bioanalysis

This report describes the development and validation of a robust robotic system that fully integrates all peripheral devices needed for the automated preparation of plasma samples by protein precipitation. The liquid handling system consisted of a Tecan Freedom EVO® 200 liquid handling platform equipped with an 8-channel liquid handling arm, two robotic plate-handling arms, and two plate shakers. Important additional components integrated into the platform were a robotic temperature-controlled centrifuge, a plate sealer, and a plate seal piercing station. These enabled unattended operation starting from a stock solution of the test compound, a set of test plasma samples and associated reagents. The stock solution of the test compound was used to prepare plasma calibration and quality control samples. Once calibration and quality control samples were prepared, precipitation of plasma proteins was achieved by addition of three volumes of acetonitrile. Integration of the peripheral devices allowed automated sequential completion of the centrifugation, plate sealing, piercing and supernatant transferral steps. The method produced a sealed, injection-ready 96-well plate of plasma extracts. Accuracy and precision of the automated system were satisfactory for the intended use: intra-day and the inter-day precision were excellent (C.V. < 5%), while the intra-day and inter-day accuracies were acceptable (relative error < 8%). The flexibility of the platform was sufficient to accommodate pharmacokinetic studies of different numbers of animals and time points. To the best of our knowledge, this represents the first complete automation of the protein precipitation method for plasma sample analysis.