Fabrication of electrospun nanofiber catalysts and ammonia borane hydrogen release efficiency

• Electrospun nanofiber catalysts were fabricated.
• Hydrogen release efficiency was investigated from NH3BH3.
• Average diameters were range from approximately 187 nm to 452 nm.
• Efficient catalytic activity towards NH3BH3 hydrogen release was detected.

In the present study, Electrospun nanofibers (Co-NF, Ni-NF, and Cu-NF) were used as efficient catalysts for hydrogen release through ammonia borane (NH3BH3) hydrolysis. Poly(vinyl alcohol) solutions containing metal acetates provided sol–gel materials for electrospinning. The electrospun fibers were fabricated by a low cost and facile technique. The effects of different process parameters such as solution preparation and electrospinning conditions that directly influence the texture, crystalline phase, and chemical properties of electrospun nanofibers fibers were studied. The nanofibers were characterized by X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FT-IR), Brunauer–Emmett–Teller surface area (BET), and scanning electron microscope (SEM). The metal oxide-loaded nanofibers with average diameters from approximately 187 to 452 nm showed catalytic activity toward increasing NH3BH3 hydrogen release efficacy, with activation energies as low as 41.59 kJ mol−1 (Co-NF), 35.54 kJ mol−1 (Ni-NF), and 36.70 kJ mol−1 (Cu-NF). Based on recyclability tests, Co-NF metal oxide nanofiber catalysts showed unaltered catalytic activity toward hydrogen release and good chemical stability after ten successive cycles.