کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1275579 | 1497536 | 2013 | 9 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Metals flow analysis applied to the hydrogen production by catalytic gasification of plastics Metals flow analysis applied to the hydrogen production by catalytic gasification of plastics](/preview/png/1275579.png)
Gasification processes can play a key role in the clean energy production from fossil and non-conventional fuels because of its transformation in a synthetic gas (syngas) rich in hydrogen and carbon monoxide. Fluidized bed reactors, both bubbling and circulating, allow to use a catalytic or reacting solid material in partial or total substitution of the bed in order to promote the dehydrogenation of the fuel. Depending on the operating conditions of reactor and of fuel type, the catalyst has a strong influence on the hydrogen yield; otherwise, the effect of catalyst add to a fluidized bed can decrease during the experimental run due to its progressive deactivation. The experimental tests demonstrated that the utilization of olivine as bed material, recognized in the literature as a good catalyst for gasification process of biomass and plastics, improves the dehydrogenation of the recycled polyethylene used as fuel by producing a hydrogen-rich syngas and a coke layer on the bed particles. The tests also indicated that the olivine was not capable to catalyse the dehydrogenation process for long time because of loss of metals diffused and linked to the carbonaceous solid (coke). A Substance Flow Analysis has been applied to the experimental data in order to evaluate the Hydrogen Recovery Efficiency for the gasification tests and to follow the repartition of metals (Fe, Ni, Mg) in the input/output streams and in the bed. The limited duration of the steady state regime as observed during the tests with olivine indicated a progressive reduction of the catalytic action correlated to the loss of metals. In other words, the use of olivine allows to obtain very high hydrogen concentration in the producer gas but for a limited time and without the possibility to recover its catalytic capacity by thermal or mechanical regeneration due to the progressive loss of metals responsible of polymer dehydrogenation. This experimental result is strictly correlated to the utilization of polyethylene as fuel. This evidence has been confirmed by analysis on olivine and fines elutriated by the reactor and showed, in this work, by a material balance on metals.
► Increase of hydrogen production by adding olivine during gasification of polymers.
► Material and substance flow analysis of tests with sand and olivine.
► Non reversible deactivation of the olivine establish an unsteady-state regime.
► Evaluation of apparent kinetic rate for iron, nickel and magnesium.
Journal: International Journal of Hydrogen Energy - Volume 38, Issue 9, 27 March 2013, Pages 3621–3629