کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1285793 | 1497932 | 2015 | 8 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: Facile synthesis of α-Fe2O3 nanoparticles on porous human hair-derived carbon as improved anode materials for lithium ion batteries Facile synthesis of α-Fe2O3 nanoparticles on porous human hair-derived carbon as improved anode materials for lithium ion batteries](/preview/png/1285793.png)
• α-Fe2O3/HHC composite was synthesized by a facile two-step process.
• Human hair-derived carbon exhibited a typical mesoporous structure.
• α-Fe2O3 was synthesized via homogeneous precipitation under microwave irradiation.
• α-Fe2O3/HHC exhibited an ultrahigh capacity and rate performance.
A hybridized composite material of α-Fe2O3 nanoparticles/human hair-derived carbon (HHC) is prepared using a facile two-step method combined carbonization of human hair with homogeneous precipitation under microwave irradiation. Results show that the uniform α-Fe2O3 nanoparticles were highly dispersed on the surface of porous human hair-derived carbon. As an anode material for Li-ion batteries, it retains a reversible capacity of 1000 mAh g−1after 200 cycles at 0.2 C. A discharge capacity higher than 750 mAh g−1and 550 mAh g−1 is also recorded at 1 C and 2 C after 200 cycles, respectively. Such superior electrochemical performance of α-Fe2O3/HHC composite could be attributed to the favorable structure of HHC, which can improve the electron and lithium ion transport ability as anode. This study provides a cost-effective, highly efficient means to fabricate materials which combine keratin wastes-derived carbon with active nanoparticles for the development of high-performance lithium-ion battery materials.
The α-Fe2O3 nanoparticles/human hair-derived carbon (HHC) composite was prepared using a facile two-step method. As an anode for lithium ion battery, the composite exhibits ultrahigh capacity and excellent high-rate cyclability.Figure optionsDownload as PowerPoint slide
Journal: Journal of Power Sources - Volume 300, 30 December 2015, Pages 104–111