کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1289723 | 973306 | 2009 | 7 صفحه PDF | دانلود رایگان |
Carbon supported Pt and Pt–Ni (1:1) nanoparticles were prepared by reduction of metal precursors with NaBH4. XRD analysis indicated that only a small amount of Ni alloyed with Pt (Ni atomic fraction in the alloy about 0.05). The as-prepared catalysts were submitted to chronoamperometry (CA) measurements to evaluate their activity for the oxygen reduction reaction (ORR). CA measurements showed that the ORR activity of the as-prepared Ni-containing catalyst was higher than that of pure Pt. Then, their stability was studied by submitting these catalysts to durability tests involving either 30 h of constant potential (CP, 0.8 V vs. RHE) operation or repetitive potential cycling (RPC, 1000 cycles) between 0.5 and 1.0 V vs. RHE at 20 mV s−1. After 30 h of CP operation at 0.8 V vs. RHE, loss of all non-alloyed Ni, partial dissolution of the Pt–Ni alloy and an increase of the crystallite size was observed for the Pt–Ni/C catalyst. The ORR activity of the Pt–Ni/C catalyst was almost stable, whereas the ORR activity of Pt/C slightly decreased with respect to the as-prepared catalyst. Loss of all non-alloyed and part of alloyed Ni was observed for the Pt–Ni/C catalyst following repetitive potential cycling. Conversely to the results of 30 h of CP operation at 0.8 V vs. RHE, after RPC the ORR activity of Pt–Ni/C was lower than that of both as-prepared Pt–Ni/C and cycled Pt/C. This result was explained in terms of Pt surface enrichment and crystallite size increase for the Pt–Ni/C catalyst.
Journal: Journal of Power Sources - Volume 191, Issue 2, 15 June 2009, Pages 344–350