Fabrication of 80 mm diameter-sized solid oxide fuel cells using a water-based NiO–YSZ slurry

Solid oxide fuel cells (SOFCs) are very attractive for their high energy conversion efficiency and low emissions. Generally, a supported layer of SOFCs is fabricated by tape casting, using an organic solvent. Recently, a slurry based on water instead of an organic solvent has been sought in order to avoid environmental pollution. In this study, the anode of SOFCs was fabricated by aqueous tape casting, and the electrolyte and the cathode were deposited by screen printing. The I–V characteristics of the cell thus obtained were evaluated. As a result, an 80 mm diameter-sized cell with a power density of 0.33 W/cm2 at 800 °C was successfully fabricated by controlling sintering conditions.