کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1552325 | 998188 | 2006 | 5 صفحه PDF | دانلود رایگان |
![عکس صفحه اول مقاله: PSI’s 1 kW imaging furnace—A tool for high-temperature chemical reactivity studies PSI’s 1 kW imaging furnace—A tool for high-temperature chemical reactivity studies](/preview/png/1552325.png)
A new experiment has been installed to conduct studies at temperatures as high as 2500 K on chemical reactions that involve solids or melts and the release of condensable gases. The sample is radiatively heated by a 1 kW xenon short arc lamp placed in the upper focus of a vertically oriented ellipsoid of revolution. The optimal optical configuration has been determined by a Monte-Carlo Ray tracing method. Several methods to machine the reflector have been evaluated by experimentally determining the optical quality of the surface of plane test pieces. In the imaging furnace the sample is placed on a water-cooled support and heated by the concentrated radiation. This arrangement allows for fast heating and impedes the reaction of the sample with crucible material. A remotely controlled hammer allows for freezing the high-temperature composition of the sample by a fast quench. Thus, the sample can be later analyzed by conventional methods such as XRD or TEM. To allow for measurements under defined atmospheres and to protect the ellipsoidal reflector from liberated condensable products, the entire sample stage is enclosed by a hemispherical glass dome. The dome itself is protected from condensable compounds by a laminar flow of inert gas. Experiments with an incense cone at the place of the sample to visualize the gas flow showed that a steady layer of inert gas protects the dome from smoke, if the inert gas flow is properly adjusted. Measured peak flux densities clearly exceed 500 W cm−2 required to access temperatures of at least 2500 K. Decomposition experiments on copper sulfides confirmed the operation of the furnace. In the near future flash assisted multi-wavelength pyrometry (FAMP) will be implemented to measure sample temperatures online. Though the imaging furnace was developed to study the decomposition of metal sulfides it is obviously suited to conduct high-temperature studies on most materials relevant for high-temperature solar technology.
Journal: Solar Energy - Volume 80, Issue 10, October 2006, Pages 1344–1348