Investigation on the structures and electrochemical performances of La0.75−xZrxMg0.25Ni3.2Co0.2Al0.1 (x = 0-0.2) electrode alloys prepared by melt spinning

In order to improve the electrochemical cycle stability of the La-Mg-Ni system A2B7-type electrode alloys, La in the alloy was partially substituted by Zr and the melt-spinning technology was used for preparing La0.75−xZrxMg0.25Ni3.2Co0.2Al0.1 (x = 0, 0.05, 0.1, 0.15, 0.2) electrode alloys. The microstructures and electrochemical performances of the as-cast and quenched alloys were investigated in detail. The results obtained by XRD, SEM and TEM showed that the as-cast and quenched alloys have a multiphase structure which is composed of two main phases (La, Mg)Ni3 and LaNi5 as well as a residual phase LaNi2. The substitution of Zr for La leads to an obvious increase of the LaNi5 phase in the alloys, and it also helps the formation of a like amorphous structure in the as-quenched alloy. The results of the electrochemical measurement indicated that the substitution of Zr for La obviously decreased the discharge capacity of the as-cast and quenched alloys, but it significantly improved their cycle stability. The discharge capacity of the alloys (x ≤ 0.1) first increased and then decreased with the variety of the quenching rate. The cycle stability of the alloys monotonously rose with increasing quenching rate.