Studies on the reduction of tensile strength of tablets after roll compaction/dry granulation

Roll compaction/dry granulation is a widely used technique for granulation. A major drawback is the reduction of tablet tensile strength compared to other granulation methods. The purpose of this study was to determine the reasons for the partial loss in compactibility.Microcrystalline cellulose of different particle sizes was roll-compacted/dry-granulated. The granules were sieved to obtain two sieve cuts and then compressed into tablets. The particle-size distribution within the sieve cut was determined using image analysis. The specific surface area of sieve cut was obtained by nitrogen adsorption. Heckel equation was used to determine the change in compressibility.The work-hardening phenomenon was found to be caused by a combination of particle-size enlargement and hardening of material. Although particle size of granules was equal, the use of smaller particles as raw material resulted in tablets with higher tensile strength due to higher specific surface area.Both work-hardening and particle-size enlargement cause the partial loss in compactibility. The reduction in tensile strength could be compensated by producing smaller granules or using raw materials with small particle sizes.