The effect of electrolyte filling method on the performance of dye-sensitized solar cells

The effect of electrolyte filling method on the performance of the dye-sensitized solar cells is investigated with the segmented cell method, a recent technique which is very simple but effective as it can be used to examine all the photovoltaic characteristics. The electrolyte filling techniques compared were single injection, which is typically used in small laboratory cells, and pumping the electrolyte through the cell several times, which is often used for larger cells and modules. Significant photovoltage and photocurrent variations occur with the repeated pumping of the electrolyte in the cell preparation. Transient and charge extraction measurements confirmed that the differences in open circuit voltage were due to the shifts of the TiO2 conduction band and time correlated single photon counting confirmed that the reduction of short circuit current was largely due to reduced electron injection correlated with the increasing conduction band edge in the studied cases. This was interpreted as an effect of molecular filtering by the TiO2 causing an accumulation of electrolyte additives (4-tert-butylpyridine and benzimidazole) near the electrolyte filling hole, the concentration of which increased with repeated pumping of the electrolyte. Interestingly, spatial variations were seen not only in the relative TiO2 conduction band energy but also in the density of trap states. In this contribution it is demonstrated how the changes in the conduction band can be separated from the changes in the density of trap states which is an essential for the correct interpretation of the data.

► Electrolyte filling method affects the performance of dye solar cells.
► Molecular filtering effect of TiO2 distributes the electrolyte components unevenly.
► Repeated pumping of the electrolyte decreases the spatial photovoltage variation.
► The spatial performance variations occur with common electrolyte compositions.