Thiosulphate leaching of gold in the presence of ethylenediaminetetraacetic acid (EDTA)

The addition of low levels of ethylenediaminetetraacetic acid (EDTA) in the ammoniacal thiosulphate gold leach system lowered the catalytic cupric/cuprous redox equilibrium potential, hence the mixed solution potential and reduced the consumption of thiosulphate. In the leaching of pure gold, gold dissolution was enhanced in the presence of EDTA at a relatively low concentration, but excessive EDTA decreased gold dissolution. Raman analysis of the leached gold foil indicated that the stabilisation of thiosulphate by EDTA decreased the formation of the passivation layers of elemental sulphur and copper sulphide at the gold surface. In the leaching of a sulphide ore, the leaching kinetics and overall extractions of gold and silver were enhanced substantially, while the consumption of ammonium thiosulphate was reduced from 9.63 kg/t to 3.85 kg/t in the presence of 2.0 mM EDTA after 24 h leaching. This beneficial effect became more pronounced at a higher EDTA concentration. The enhanced gold and silver extractions by EDTA were attributed to the increase in the dissolution of gold and silver bearing sulphides, the stabilisation of copper and thiosulphate in leach solutions, the prevention of leaching passivation and the decrease in the interference of foreign heavy metal ions. The use of EDTA in the ammoniacal thiosulphate leaching system makes it practical to achieve satisfactory gold extraction over extended periods of leaching under low reagent concentrations, where the consumption of thiosulphate is low.