Stretch-induced wrinkling of polyethylene thin sheets: Experiments and modeling

This paper presents a study on stretch-induced wrinkling of thin polyethylene sheets when subjected to uniaxial stretch with two clamped ends. Three-dimensional digital image correlation was used to measure the wrinkling deformation. It was observed that the wrinkle amplitude increased as the nominal strain increased up to around 10%, but then decreased at larger strain levels. This behavior is consistent with results of finite element simulations for a hyperelastic thin sheet reported previously (Nayyar et al., 2011). However, wrinkles in the polyethylene sheet were not fully flattened out at large strains (>30%) as predicted for the hyperelastic sheet, but exhibited a residual wrinkle whose amplitude depended on the loading rate. This is attributed to the viscoelastic response of the material. Two different viscoelastic models were adopted in finite element simulations to study the effects of viscoelasticity on wrinkling and to improve the agreement with the experiments, including residual wrinkles and rate dependence. It is found that a parallel network model of nonlinear viscoelasticity is suitable for simulating the constitutive behavior and stretch-induced wrinkling of the polyethylene sheets.