A reinterpretation of measurements in developing annular two-phase flow

Measurements of developing films in adiabatic high pressure steam-water flow in annular geometry have been reanalyzed and compared to a linearized film-flow model. The development rate of the outer film could be determined with good accuracy in four cases. In one case it was also possible to conclude that the inner film develops faster than the outer one. When compared to the linearized model, these observations show that the deposition rate has to be almost independent of the drop concentration at the investigated conditions. Furthermore, any significant deposition by direct impaction of drops can be excluded as it would couple the development of the two films. These conclusions are quite general and do not depend on the use of any particular correlation for the deposition or entrainment rates. Finally, a rough estimate of the deposition rate was possible, confirming that deposition rates are considerably lower at high pressure steam-water flows than in air-water flows.

Research highlights
► Measurements of developing liquid films in annular geometry reanalyzed.
► Inner film develops faster than the outer one.
► Deposition rate has to be almost independent of the drop concentration.
► Direct impaction of drops can be excluded.