Dimensional error in selective laser sintering and 3D-printing of models for craniomaxillary anatomy reconstruction

SummaryBackgroundSelective laser sintering (SLS) and three-dimensional printing (3DP™) are rapid prototyping (RP) techniques to fabricate prototypes from biomedical images. To be used in maxillofacial surgery, these models must accurately reproduce the craniofacial skeleton.PurposeTo analyze the capacity of SLS and 3DP™ models to reproduce craniomaxillary anatomy and their dimensional error.MaterialDry skull, helical computed-tomography images, SLS and 3DP™ prototypes, and electronic calliper.MethodsTomographic images of a dry skull were manipulated with the InVesalius biomedical software. Prototypes were fabricated using SLS and 3DP™ techniques. Ten linear measurements were made on the models and compared with corresponding dry skull measurements (criterion standard) carried out with an electronic calliper.ResultsWe observed a dimensional error of 2.10 and 2.67% for SLS and 3DP™ models, respectively. The models satisfactorily reproduced anatomic details, except for thin bones, small foramina and acute bone projections. The SLS prototypes showed greater dimensional precision and reproduced craniomaxillary anatomy more accurately than the 3DP™ models.ConclusionBoth SLS and 3DP™ models provided acceptable precision and may be useful aids in most maxillofacial surgeries.