Radiocarbon analysis on organic and elemental carbon in aerosol samples and source apportionment at an urban site in Northern Italy

This work aims at gaining information on the effects of different thermal treatments on radiocarbon measurements of organic (OC) and elemental (EC) carbon fractions in the atmospheric aerosol. Improvements to the traditional approaches for the determination of the fraction of modern carbon of OC and EC−fm(OC) and fm(EC)- are proposed.As for fm(EC) determination, we propose to add a He step at high temperature to the standard oxygen treatment. Our tests demonstrate that the addition of a high temperature He step (final choice: 750 °C) to the oxygen treatment is effective in removing the refractory OC.As for fm(OC) determination, we propose to quantify it by measuring either the fraction of modern carbon of TC and EC or the fraction of modern carbon of water soluble (fm(WSOC)) and water insoluble (fm(WINSOC)) organic carbon to limit the influence of possible pyrolysis on the direct determination of fm(OC). Tests on the equivalence of the approaches have shown good agreement between them.Our tests were carried out on samples collected in a heavily polluted area (Milan, Italy) during wintertime. fm(OC), fm(EC), and fm(TC) values obtained in our tests were also used to attempt a preliminary source apportionment in the area using 14C measurements. Wintertime EC resulted to be mainly fossil (84%), whereas OC was dominated by modern contribution (63%).Two approaches were tested for the evaluation of the wood burning contribution to OC and a good agreement was found. Wood burning primary contribution accounted for about 18% of OC in Milan during wintertime.Secondary OC from biomass burning and the contribution from other urban sources were tentatively identified following literature approaches, with the aim of evaluating the biogenic contribution to OC in the area, which was estimated to be about 18%.

► Improvements to thermal protocols for 14C analysis of OC and EC were carried out.
► A suitable filter washing procedure was set up.
► A high temperature He step was added to the oxygen step to improve EC isolation.
► Two alternative approaches for fm(OC) determination were tested.
► Carbonaceous particles source apportionment was attempted.