Comparison of batch leaching tests and influence of pH on the release of metals from construction and demolition wastes

Construction and demolition wastes are suitable for use in road construction. However, leaching characterization of recycled materials is required to determine their pollutant potential and the consequence of their application in different scenarios. The motivation of this paper is derived from the increasing use of different leaching test methods. In Europe, the confusion resulting from the wide variety of tests used to evaluate environmental properties of construction materials implies that an evaluation of the current practices and the attempt to consolidate the approaches are required.Two equilibrium-based leaching tests (the Dutch test and the European standard) were conducted to assess the environmental impact of four recycled aggregates. Three natural limestone aggregates were used as controls. Both tests measure the potential release of hazardous elements under extreme conditions using different leaching parameters (L/S ratio, pH value and contact time). The results proved that pH is the most relevant factor on the assessment of the differences between leaching methods due to its strong control on the pollutant release.To classify the materials according to their environmental effects, the concentration limit values of the metals imposed by Council Decision 2003/33/EC were used as a reference. The comparison allowed the classification of the recycled aggregates as inert wastes, with the exception of the MR-2 aggregate, which was classified as non-hazardous material.

► We compare two leaching procedures for granular materials UNE 12457 and NEN 7341.
► We analyze the effect of testing parameters on the emission of ten heavy metals.
► Tested materials were classified according to metal concentration on leachates.
► Seven recycled aggregates were classified as inert materials.
► The relevant effect of the pH on the pollutant metal release was proved.