Centrifuge model study on geogrid reinforced soil walls with marginal backfills with and without chimney sand drain

The objective of this paper is to investigate the performance of geogrid reinforced soil walls with panel facing using marginal backfill with and without chimney sand drain subjected to seepage. A series of centrifuge model tests were performed at 40 gravities using a 4.5 m radius large beam centrifuge facility available at IIT Bombay. The results revealed that a geogrid reinforced soil wall with low stiffness geogrid and without any chimney drain experienced a catastrophic failure due to excess pore water pressure that developed in the reinforced and backfill zones at the onset of seepage. In comparison, a soil wall reinforced with stiff geogrid layers was found to perform effectively even at the onset of seepage. Provision of chimney sand drain effectively decreased pore water pressure not only at the wall toe but also at mid-distance from toe of the wall and thereby resulted in enhancing the wall performance under the effect of seepage forces. However, a local piping failure was observed near the toe region of the wall. The observed centrifuge test results were further analysed by performing seepage and stability analyses to evaluate the effect of thickness of sand layer in a chimney drain. An increase in thickness of sand layer in chimney drain was found to improve the discharge values and thereby enhancing the factor of safety against piping near the toe region. Based on the analysis and interpretation of centrifuge test results, it can be concluded that marginal soil can be used as a backfill in reinforced soil walls provided, it has geogrid layers of adequate stiffness and/or proper chimney drain configuration.