Phase separation and dewetting in polystyrene/poly(vinyl methyl ether) blend thin films in a wide thickness range

Phase separation and dewetting processes of blend thin films of polystyrene (PS) and poly(vinyl methyl ether) (PVME) in two phase region have been studied in a wide film thickness range from 65 μm to 42 nm (∼2.5Rg, Rg being radius of gyration of a polymer) using optical microscope (OM), atomic force microscope (AFM) and small-angle light scattering (LS). It was found that both phase separation and dewetting processes depend on the film thickness and were classified into four thickness regions. In the first region above ∼15 μm the spinodal decomposition (SD) type phase separation occurs in a similar manner to bulk and no dewetting is observed. This region can be regarded as bulk. In the second region between ∼15 and ∼1 μm, the SD type phase separation proceeds in the early stage while the characteristic wavelength of the SD decreases with the film thickness. In the late stage dewetting is induced by the phase separation. In the third region between ∼1 μm and ∼200 nm the dewetting is observed even in the early stage. The dewetting morphology is very irregular and no definite characteristic wavelength is observed. It is expected that the irregular morphology is induced by mixing up the characteristic wavelengths of the phase separation and the dewetting. In the fourth region below ∼200 nm the dewetting occurs after a long incubation time with a characteristic wavelength, which decreases with the film thickness. It is considered that the layered structure is formed in the thin film during the incubation period and triggers the dewetting through the capillary fluctuation mechanism or the composition fluctuation one.