The thermal effects on electrospinning of polylactic acid melts

We demonstrate that melt electrospinning can be a feasible way to produce sub-micron scale polylactic acid (PLA) fibers in this paper. This solvent-free approach to produce sub-micron scale fibers is more environmentally benign than common solution electrospinning processes, and has a potential to increase the production rate significantly. Our experimental results show that temperatures at the spinneret and in the spinning region are critical to produce sub-micron sized fibers: a high-speed photographic investigation reveals that when spinning temperature is below glass transition temperature, whipping of the jet is suppressed by fast solidification in the spinning region, leading to a larger jet diameter. Both thermal and mechanical degradations of PLA in melt electrospinning can be significant but no change in chemical composition is found. Due to rapid solidification, melt electrospun PLA fibers are mostly amorphous, and the small presence of β crystals is noted in the sub-micron scale PLA fibers by XRD studies. The highly oriented structure of PLA fibers gives rise to cold crystallization at around 95 °C, and the degree of crystallinity of fibers increases with increasing the degree of annealing. Finally, PLA nanofibers have directly been electrospun onto cellulose filter media, and a drastic enhancement in collection efficiency of sub-micron sized dust particles is presented. Melt electrospun PLA nanofiber mats with no residual solvent may serve as better filter media and tissue scaffolds than those obtained from solution electrospinning processes.