کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
5205974 1502944 2015 9 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Effects of ultrahigh molecular weight polyethylene and mould temperature on morphological evolution of isotactic polypropylene at micro-injection moulding condition
ترجمه فارسی عنوان
اثر پلی اتیلن وزن مولکولی فوق العاده و دمای قالب بر تکامل مورفولوژی پلی استایرن ایزوتاکتیک در شرایط قالب گیری میکرو تزریق
کلمات کلیدی
اثرات، دمای قالب کریستال ²² مانند بسته نرم افزاری ریخته گری میکرو تزریق،
موضوعات مرتبط
مهندسی و علوم پایه شیمی شیمی آلی
چکیده انگلیسی
The effects of ultrahigh molecular weight polyethylene (UHMWPE) and mould temperature (Tmould) on an isotactic polypropylene (iPP) matrix moulded via micro-injection were investigated via polarized light microscopy, scanning electron microscopy, differential scanning calorimetry, wide-angle X-ray diffraction and small-angle X-ray scattering. Results showed that the complex viscosity of the system increased significantly when the UHMWPE content was more than 5%; however, this viscosity decreased when the UHMWPE content was less than 5%. In addition, the addition of UHMWPE increased the onset of crystallisation temperature and the relative crystallinity of the β-form crystals in micro-injection moulded specimens. Moreover, the UHMWPE phase induced the formation of fan-shaped β crystals in iPP/UHMWPE blends. When mould temperature was 50 °C, the degree of orientation of microparts increased and the crystalline structures were highly compact. However, the relative crystallinity of the β-phase form (Kβ) was lower than those prepared at 130 °C Tmould. Most importantly, well-oriented, bundle-like β crystals have been discovered for the first time in 5 wt.% UHMWPE/iPP blends obtained at 130 °C Tmould owing to the “orientation-maintenance” and “shear-amplification” effects of UHMWPE.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Polymer Testing - Volume 46, September 2015, Pages 41-49
نویسندگان
, , , , , ,