کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
5468986 1519053 2017 7 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Sand fraction effect on hydro-mechanical behavior of sand-clay mixture
ترجمه فارسی عنوان
اثر کسر شن در رفتار هیدروکربنی مخلوط شن و ماسه
کلمات کلیدی
مخلوط شن و ماسه، شن و ماسه، رفتار هیدرو مکانیکی، مدل چهار فاز تشکیل اسکلت ماسه،
ترجمه چکیده
مخلوط ماسه و خاک رس برای شبیه سازی خاک های ویژه با تسطیح قطع شد، به عنوان مثال خاک های باقی مانده، کولینوس ها یا خاک های پرشدن هیدرولیکی. برای بررسی رفتارهای آبی و مکانیکی خود، آزمایشهای بارگیری مزبور با استفاده از این تست انجام شد. نتایج ابتدا براساس توطئه های هواپیما نیمه لگاریتمی تجزیه و تحلیل شد (به عنوان مثال نسبت ولادی نرمال به آن در حد مایع در مقابل استرس موثر عمودی و در مقایسه با هدایت هیدرولیکی). به نظر می رسد که نسبت تخلخل نرمال شده توسط آن در حد مایع به نرمال بودن ارزشمند و قابل اعتماد از منحنی های فشرده سازی و نفوذ پذیری کمک می کند. برای بررسی تأثیر کسر ماسه، یک مدل چهار فاز مخلوط شن و ماسه معرفی شد، که امکان تعیین نسبت خاک رس و ماسه را فراهم می آورد. تجزیه و تحلیل بیشتر نشان داد که نسبت خلوص شن و خنثی و نسبت خلوص طبیعی طبیعی با آن در حد مایع، پارامترهای مناسب برای توصیف تشکیل اسکلت شن و ماسه نیز هستند. علاوه بر این، نسبت تخلخل خاک نرمال به مقدار در حد مایع، یک پارامتر مناسب برای توصیف رفتار هیدرولیکی خاک با یا بدون شن و ماسه است. هنگامی که اسکلت شن و ماسه تا حدی شکل گرفت، استرس عمودی تا حدی توسط اسکلت پشتیبانی می شد که منجر به رفتار فشرده سازی متفاوت از آن از رس ها می شد. شکل گیری جزئی اسکلت براساس رابطه نسبی دانه های درشت تا دانه و همچنین وضعیت استرس بستگی دارد. این بدان معنی است که در طی فشرده سازی، اثر متقابل بین ماسه و خاک رس، از اسکلت ماسه ای غیر، جزئی و کامل به رسیدن به انتهای حداکثر مقدار خلوص شن و ماسه می رسد.
موضوعات مرتبط
مهندسی و علوم پایه علوم زمین و سیارات ژئوشیمی و پترولوژی
چکیده انگلیسی
The sand-clay mixture was prepared to simulate special soils with discontinuous gradations, e.g. the residual soils, clinosols or hydraulic filling soils. Incremental loading oedometer tests were conducted to investigate their hydro-mechanical behaviors. The results were first analyzed based on the plots in the semi-logarithmic planes (i.e. normalized void ratio by that at liquid limit versus vertical effective stress, and versus hydraulic conductivity). It appears that the normalized void ratio by that at liquid limit allows valuable and reliable normalization of the compressibility and permeability curves. To investigate the influence of sand fraction, a four-phase model of sand-clay mixture was introduced, enabling the void ratios of clay and sand to be determined. Further analysis showed that the sand void ratio and the normalized clay void ratio by that at liquid limit are also suitable parameters to describe the sand skeleton formation. Moreover, the normalized clay void ratio by that at liquid limit is an appropriate parameter to describe the hydraulic behavior of soils with or without sand fraction. When the sand skeleton was partly formed, the vertical stress was partly supported by the skeleton resulting in a different compression behavior from that of common clays. The partial formation of skeleton was found to depend on the relative dimension of coarse to fine grains as well as the stress state. This implies that during compression the interaction between sand and clay evolves, from non-, partial- to complete sand skeleton, reaching at the end of the maximum void ratio of sand.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Applied Clay Science - Volume 135, January 2017, Pages 355-361
نویسندگان
, , , , ,