Study on emission of hazardous trace elements in a 350Â MW coal-fired power plant. Part 2. arsenic, chromium, barium, manganese, lead

- Emission characteristics of HTEs at three different loads and coal types in the same power plant were investigated.
- The five studied HTEs (As, Cr, Ba, Mn, Pb) mainly distribute in bottom and ESP + FF.
- Co-removal rate across APCDs ranges from 99.84 to 99.99%, and emission factor is 0.04-1.54 g/1012J.
- Content of As, Pb, Ba, Cr follows ESP + FF ash > bottom ash > gypsum, and Mn in WFGD wastewater is excessive.

Hazardous Trace elements (HTEs) emitted from coal combustion has raised widespread concern. Studies on the emission characteristics of five HTEs, namely arsenic (As), chromium (Cr), barium (Ba), manganese (Mn), lead (Pb) at three different loads (100%, 83%, 71% output) and different coal types were performed on a 350 MW coal-fired power plant equipped with SCR, ESP + FF, and WFGD. HTEs in the flue gas at the inlet/outlet of each air pollution control device (APCD) were sampled simultaneously based on US EPA Method 29. During flue gas HTEs sampling, coal, bottom ash, fly ash captured by ESP + FF, fresh desulfurization slurry, desulfurization wastewater were also collected. Results show that mass balance rate for the system and each APCD is in an acceptable range. The five studied HTEs mainly distribute in bottom and ESP + FF ash. ESP + FF have high removal efficiency of 99.75-99.95%. WFGD can remove part of HTEs further. Total removal rate across the APCDs ranges from 99.84 to 99.99%. Concentration of HTEs emitted to atmosphere is within the extremely low scope of 0.11-4.93 μg/m3. Emission factor of the five studied HTEs is 0.04-1.54 g/1012J. Content of As, Pb, Ba, Cr in solid samples follows the order of ESP + FF ash > bottom ash > gypsum. More focus should be placed on Mn in desulfuration wastewater, content of which is more than the standard value. This work is meaningful for the prediction and removal of HTEs emitted from coal-fired power plants.

297