Assessment of atmospheric trace metal deposition in urban environments using direct and indirect measurement methodology and contributions from wet and dry depositions

- Dry, Wet and Bulk Atmospheric Depositions were measured in an urban residential area.
- Dry Depositions were measured using a new method based on 7Be deposition velocities.
- 7Be deposition method appears better than the subtraction Bulk minus Wet Depositions.
- The mean contribution of Dry to Bulk Deposition was significant for Zn, Cu, V and Pb.
- A detailed evaluation of uncertainties validates the method.

Bulk Atmospheric Deposition (BAD), Wet Atmospheric Deposition (WAD) and Dry Atmospheric Deposition (DAD) were all measured within an urban residential area in Nantes (France) over a 9-month period (27 February - 10 December 2014). The objectives of this study were to compare 2 methods for measuring dry and wet atmospheric depositions in the urban environment (DAD and WAD: direct method; BAD and WAD: indirect one), and to characterize as well the variations and relative contributions of these depositions. Trace metals (As, Cd, Cr, Cu, Ni, Pt and V) were used to carry out these comparison and quantification. BAD was collected with two open polyethylene containers (72 × 54 × 21 cm), while WAD was collected by means of an automated rainwater collector and DAD was determined from both air measurements (recorded by an air sampler) and 7Be deposition velocities. The comparison based on a detailed evaluation of uncertainties showed a significant difference between the direct and indirect methods. Dry and wet depositions varied widely from one month to the next. Zn and Cu were the most abundant elements in both dry and wet depositions. The mean contribution of DAD to the bulk atmospheric deposition during this 9-month study was significant for Zn, Cu and V (about 25%) as well as for Pb (approx. 60%). For this relatively unpolluted urban residential catchment, the contribution of atmospheric deposition to global load at the catchment outlet was low, between 10% and 20% for Zn, Cu, V and Pb, 25% for Cr and about 30% for Ni. For other urban sites exhibiting high atmospheric pollution however, the atmospheric contribution to the global pollution load could be much greater. An accurate and representative estimation of DAD thus proves critical.