Modeling the initial flame acceleration in an obstructed channel using large eddy simulation

The propagation and acceleration of a flame surface past obstructions in a closed square channel was investigated using large eddy simulation. The dynamic Smagorinsky–Lilly subgrid model and the Boger flame surface density combustion model were used. The geometry is essentially two-dimensional with fence-type obstacles distributed on the top and bottom surfaces, equally spaced along the channel length at the channel height. Flame propagation, however, is three dimensional as ignition occurs at a point at the center of the channel cross-section. The effect of obstacle blockage ratio on the development of the flame structure was investigated by varying the obstacle height. Three-dimensional cases were simulated from the initiation of a combustion kernel through spark ignition to the acceleration of the flame front at speeds up to 80 m/s. The transition from laminar flame propagation to turbulent flame propagation within the “thin reaction zone” regime was observed in the simulations. By analyzing the development of the three dimensional flame surface and unburned gas flow field, the formation of several flame structures observed experimentally are explained. Global quantities such as the total flame area and centerline flame velocity were ascertained and compared to the experimental data. High amplitude oscillations in the centerline flame velocity were found to occur from a combination of the unburned gas flow field and fluctuations in the volumetric burning rate.

► We modeled flame acceleration in a closed channel and compared results to experimental schlieren images.
► We investigated the effect of obstacle blockage ratio on the development of the unburned gas flow.
► Determined that the flame shape, velocity, and area are heavily influenced by unburned gas flow development.
► The unburned gas flow is dominated by the growth of recirculation zones and shedding of vortices into the shear layer.