کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
658353 | 1458082 | 2013 | 11 صفحه PDF | دانلود رایگان |
عنوان انگلیسی مقاله ISI
Oscillating heat pipe simulation considering bubble generation Part II: Effects of fitting and design parameters
دانلود مقاله + سفارش ترجمه
دانلود مقاله ISI انگلیسی
رایگان برای ایرانیان
کلمات کلیدی
موضوعات مرتبط
مهندسی و علوم پایه
مهندسی شیمی
جریان سیال و فرایندهای انتقال
پیش نمایش صفحه اول مقاله
چکیده انگلیسی
In the part I, the OHP simulations with and without the TS bubble generation have been performed. In those simulations, four fitting and six design parameters were used. In this paper, the effects of both design and fitting parameters are investigated in the simulations with and without the TS bubble generation. The fitting parameters are the coefficient of phase change (α), evaporation coefficient on the TS bubble (αb), initial length of the TS bubble (Lb) and degree of superheat (ÎTsup). The design parameters are the nucleation site (NS) configurations, NS positions, number of NSs, temperature of heating section, number of liquid slugs and vapor plugs, and number of turns. The results show that both the fitting and design parameters influence the motions of liquid slugs and vapor plugs, pressure difference between two vapor plugs (driving force) and heat transfer rates of an OHP. The effects of the combinations of design parameters are also investigated. The results show that the motions of liquid slugs and vapor plugs becomes complex (unsteady oscillating motions) due to the random TS bubbles generation. The profile of heat transfer rates also becomes random due to the complex motions.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Heat and Mass Transfer - Volume 60, May 2013, Pages 825-835
Journal: International Journal of Heat and Mass Transfer - Volume 60, May 2013, Pages 825-835
نویسندگان
Raffles Senjaya, Takayoshi Inoue,