Heat transfer enhancement using air-atomized spray cooling with water-Al2O3 nanofluid

The study deals with the air-atomized spray cooling using nanofluid as the cooling media for high heat flux applications. The nanofluid has been prepared by commercial Al2O3 particles of diameter less than 13 nm and water. Heat transfer study has been carried out on a pre-heated steel specimen of dimensions 100 mm × 100 mm × 6 mm. The initial temperature of the plate which was subjected to air-atomized spray cooling was over 900 °C. Various coolants consisting of 0.1% volumetric concentration of water-Al2O3 mixture, with or without a dispersing agent (surfactant) were used for the study. The dispersing agents used are sodium dodecyl sulphate (SDS) and polyoxyethylene (20) sorbitan monolaurate (Tween 20). Inverse heat conduction software INTEMP has been used for estimating the surface heat flux and temperatures taking into account the measured internal temperature histories by the thermocouples during the cooling process. The results obtained using nanofluid coolants are compared with that of the results where pure water (filtered potable water) is used as a coolant. The analyses reveal that the cooling rate, critical heat flux and heat transfer coefficients are significantly enhanced when nanofluids are used as coolants in air-atomized spray process. Also, the nanofluid coolants with dispersing agent shows a better enhancement of heat transfer over that of the nanofluid without the dispersing media. The nanofluid with dispersing agent Tween 20 is found more effective than that of its counterpart. Overall, the percentage enhancement in cooling rate of all these nanofluids compared with pure water (filtered potable water) is 10.2% for water-Al2O3, 18.6% for water-Al2O3-SDS, and upto 32.3% for water-Al2O3-Tween 20.