Degradation and recovery of adhesion properties of deformed metal–polymer interfaces studied by laser induced delamination

Adhesion properties of polymer coatings on metals are of great interest in various industrial applications, including packaging of food and drinks. Particular interest is focused on polymer–metal interfaces that are subjected to significant deformations during manufacturing process. In this work steel samples laminated with polyethylene terephthalate (PET) were subjected to uniaxial tensile deformations followed by annealing treatments. The measurements have demonstrated degradation of adhesion of the metal–polymer interface as the strain introduced by the deformation increased. Moreover, it was observed that within the geometry used in the experiments tensile deformations of the metal substrate introduced in-plane compressive stresses in the bulk of the coating. After applying a thermal treatment restoration of the adhesion has been achieved.Laser induced delamination technique was used to monitor the adhesion properties. In this technique a coating is subjected to a series of infrared laser pulses with a stepwise increase of intensity. Upon increasing the laser pulse intensity, the pressure which is formed inside the blisters reaches a critical value, resulting in further delamination of the coating. To process the experimental data an elastic model was developed. From the analysis of the experimental data the critical stresses required for the delamination and the practical work of adhesion are derived. The model accounts for the compressive in-plane stress present in the coating of the deformed samples.