Diamond coating on hard metals by traveling methods in a plasma-assisted chemical vapor deposition method above the liquid

In this work, two approaches were developed to extend the coating area of diamond by continuous deposition in a plasma-assisted chemical vapor deposition (CVD) method above the liquid. The techniques were based on the methods previously developed by our research group and the characteristic was to use dc (direct current) plasma generated between the liquid surface and the metal electrode. In the first approach, a tungsten rod was rotated in a chamber at reduced pressure so that a diamond film was formed as a ‘belt’ in 6 mm width around the side of the rod. The deposited diamond was polycrystalline with a grain size of 1–3 μm. The film thickness increased almost linearly with deposition time, whereas the grain size was almost constant against the deposition time. The second approach was for a plate substrate. A tungsten plate was hung with an iron wire and the plasma was horizontally generated between the liquid and plate surfaces. When the W plate was vertically slid down slowly, a diamond film was continuously deposited on the surface. The deposited film was covered with a soot-like carbon layer on the top and the post-treatment with H2O/N2 gas at 600 °C was effective in removing it. The continuous deposition successfully demonstrated the expansion of the deposition area with the novel plasma CVD method above the liquid.