کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
7054138 1458016 2018 15 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Mixing improvement induced by the combination of a micro-ramp with an air porthole in the transverse gaseous injection flow field
ترجمه فارسی عنوان
بهبود مخلوط شده بوسیله ترکیبی از یک رمپ میکرو با یک توربو هوا در میدان جریان تزریق گشتاور
کلمات کلیدی
تزریق متقاطع رمپ میکرو، چرخه هوا، طول مخلوط کردن، عمق نفوذ، از دست دادن فشار رکود،
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی جریان سیال و فرایندهای انتقال
چکیده انگلیسی
A new injection strategy combined with a micro-ramp and an air porthole is proposed in this paper, and the properties of the transverse gaseous injection flow field with such injection strategy have been investigated simultaneously. The numerical approach employed in the current study has been validated against the two-dimensional and three-dimensional experimental data in the open literature, and it can be used with confidence to investigate the influence of the air porthole aspect ratio and the distance between the air porthole and the fuel orifice on the transverse injection flow field with the combination of a micro-ramp and an air porthole. The obtained results predicted by the three-dimensional Reynolds-average Navier-Stokes (RANS) equations coupled with the two equation k-ω shear stress transport (SST) turbulence model show that the mixing performances of the transverse gaseous injection flow fields vary under different conditions, and a transverse injection flow field with short mixing length, low stagnation pressure loss and ideal fuel penetration depth has been achieved by adding the combination of an optimized micro-ramp with a proper air porthole, i.e. Case 6-8, and its mixing length decreases considerably by 14.26 mm on the basis of Case c, even shorter than the mixing length of Case a by 2.86 mm. However, its total pressure loss increases when compared with Case c, and its stagnation pressure loss is 2.7 percent smaller than Case a. Further, the hydrogen distribution on the flat plate of Case 6-8 is much less than that of Case a and Case b. Additionally, it is found that the mixing enhancement mechanism of the air jet is different from that of the micro-ramp. The micro-ramp enhances the mixing process between the fuel and air by inducing large-scale vortices, while the air porthole enhances the mixing process by seeding lots of air into the fuel boundary layer, as well as fuel plume.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Heat and Mass Transfer - Volume 124, September 2018, Pages 109-123
نویسندگان
, , , , ,