کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
7054530 1458020 2018 11 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
Comparison of the pseudo-single-phase continuum model and the homogeneous single-phase model of nanofluids
ترجمه فارسی عنوان
مقایسه مدل پیوسته تک فاز و مدل تک فاز همگن نانوفیلد
کلمات کلیدی
نانوفیلد ها، انعطاف پذیر مدل تک فاز همگن، مدل پیوسته تک فاز،
ترجمه چکیده
ما بررسی اتصال اجباری یک نانوسیم در ناحیه ورودی سیلندر و در منطقه به طور کامل توسعه یک سیلندر کواکسیال که با استفاده از مدل پیوسته تقسیم فاز و مدل تک فاز همگن انجام می شود. در حالی که مدل تک فاز همگن، توزیع نانوذرات یکنواخت را در بر میگیرد، مدل پیوسته یکپارچه فاز، از توزیع نانوذرات غیرمستقیم مراقبت می کند. در مورد علت افزایش انتقال گرما در نانوفیلد ها بحث برانگیز بوده است. این که آیا آن تنها توسط تغییرات خواص ترموفیزیکی یا توزیع نانوذرات ایجاد می شود نیز بر آن تأثیر می گذارد. این اختلاف ممکن است با استفاده از این دو مدل حل شود. یافته شده است که نانوذرات از دیواره داغ به منطقه سرد سرد در ناحیه ورودی رانده می شوند، در حالی که از طریق سطح سرامیکی داخلی به سطح بیرونی داغ در سیلندر کواکسیال کاملا توسعه یافته به دلیل ترمو فورئیز رانده می شود. توزیع غیر توانی نانوذرات به دست آمده باعث افزایشی افزایش انتقال حرارت می شود. از سوی دیگر، هنگامی که میزان انتقال گرما افزایش می یابد، جریان اصطکاک افزایش می یابد. به یک معنی، افزایش میزان انتقال حرارت به میزانی به هزینه مصرف انرژی بالاتر به دست می آید.
موضوعات مرتبط
مهندسی و علوم پایه مهندسی شیمی جریان سیال و فرایندهای انتقال
چکیده انگلیسی
We investigate forced convection of a nanofluid in the entrance region of a cylinder and in the fully-developed region of a coaxial cylinder employing the pseudo-single-phase continuum model and the homogeneous single-phase model. While the homogeneous single-phase model assumes a uniform nanoparticle distribution, the pseudo-single-phase continuum model takes care of nonuniform nanoparticle distribution. There has been controversy regarding the cause of heat transfer enhancement in nanofluids. Whether it is caused solely by the variation of thermophysical properties or the nanoparticle distribution also affect it. This controversy may be resolved employing these two models. It is found that nanoparticles drift from hot wall to cold central region in the entrance region, while they drift from cold inner surface to hot outer surface in the fully-developed coaxial cylinder due to the thermophoresis. The resulting nonuniform distributions of nanoparticles are found to add the heat transfer enhancement slightly. On the other hand, the frictional dissipation increases when the heat transfer rate increases. In a sense, the enhanced heat transfer rate is partly achieved at the expense of a higher energy consumption.
ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: International Journal of Heat and Mass Transfer - Volume 120, May 2018, Pages 106-116
نویسندگان
,