کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
747908 | 894716 | 2011 | 5 صفحه PDF | دانلود رایگان |

We report on four-point probe measurements on SiC wafers as such measurements give erratic data. Current–voltage measurements on n-type SiC wafers doped to 3 × 1018 cm−3 are non-linear and single probe I–V measurements are symmetrical for positive and negative voltages. For comparison, similar measurements of p-type Si doped to 5 × 1014 cm−3 gave linear I–V, well-defined sheet resistance and the single probe I–V curves were asymmetrical indicating typical Schottky diode behavior. We believe that the reason for the non-linearity in four-point probe measurements on SiC is the high contact resistance. Calculations predict the contact resistance of SiC to be approximately 1012 Ω which is of the order of the input resistance of the voltmeter in our four-point probe measurements. There was almost no change in two-probe I–V curves when the spacing between the probes was changed from 1 mm to 2 cm, further supporting the idea that the I–V characteristics are dominated by the contact resistance.
► Four-point probe measurements on SiC produce non-sensible results.
► High contact resistance interferes with four-point probe voltage measurement.
► One- and two-probe I–V measurements indicate thermionic-field emission.
► Contact resistance dominates I–V behavior.
Journal: Solid-State Electronics - Volume 64, Issue 1, October 2011, Pages 73–77