Fatigue strength assessment of laser stake-welded T-joints using local approaches

• Five local approaches to the fatigue strength assessment are applied.
• Eight series involving 73 specimens of laser stake-welded T-joints are considered.
• Fatigue strength of T-joints agrees with other joints mostly at five million cycles.
• The slope of the fatigue resistance curves varies for different loading conditions.
• The slope values obtained by different approaches agree well for all series.

This study investigates the applicability of local stress- and energy-based approaches to the fatigue strength assessment of laser stake-welded T-joints. The T-joint has two crack-like notches with infinitesimal tip rounding on each side of the weld. The local approaches used are fictitious tip rounding of 1 and 0.05 mm and the approaches that assume zero rounding within this study, namely the stress intensity factor, the average strain energy density and the J-integral.It is shown that the slopes of the fatigue resistance curves vary between 4 and 8 under different loading conditions imposed on the joint. The slope value exhibits a linear relation with the dimensionless gradient of the maximum principal stress evaluated at the critical notch tip. The same linear relation between the slope and the gradient is valid for all approaches. Because of the slopes, which differ from the usual 3, the agreement of the T-joints with other steel joints is obtained at five million load cycles. The exception is the fictitious rounding concept of 0.05 mm, in which case the recommended design S–N curve with a slope of 3 appears overly conservative in a high-cycle regime.