The effect of wet foam stability on the microstructure and strength of porous ceramics

Wet foam stability is of prime importance in fabricating porous ceramics with the desired microstructure and mechanical properties. In this research, wet foams were fabricated via direct foaming after separately adding an anionic surfactant (TLS) and a cationic surfactant (DTAC) into alumina slurries with a copolymer of isobutylene and maleic anhydride (PIBM) as both the dispersant and the gelling agent. The foam stability was evaluated by a stability analyzer. The bubble size rapidly increased in the wet foam with TLS as the foam stabilizer and many large bubbles appeared within 60 min. The wet foam containing DTAC was very stable. Cationic DTAC increased the hydrophobicity of alumina particles by interacting with the anionic PIBM adsorbed on the particles. The hydrophobically modified particles acted as the foam stabilizer and enhanced the wet foam stability. Furthermore, the fast gelling speed of the slurry containing DTAC also enhanced the wet foam stability. The average cell size of the ceramic with 82.9% porosity from the wet foam with TLS was 188 µm and the compressive strength was 9.7 MPa. The counterparts from the wet foam with DTAC were 54 µm of average cell size and 18.1 MPa of compressive strength. The superior stability of wet foam brought about a smaller cell size and higher strength of the resultant ceramic.