Anisotropy of hygrothermal damage in fiber/polymer composites: Effective elasticity measures and estimates

Measured elasticity moduli of a highly (68%) glass-fiber reinforced epoxy matrix for different amounts of fiber/matrix interface weakening and debonding, due to different hygrothermal ageing stages, are compared to estimated ones. Ultrasonic measurements provide seven of the nine elasticity moduli of the orthotropic material samples, including all the moduli significantly affected by damage. Theoretical estimates combine homogenization modeling techniques and Finite Element (FE) calculations, the latter when the effect of observed partial debonding on effective moduli is to be specified. These estimates are performed under different assumptions for the composite structure, with special attention to the existence of a fiber–matrix interphase. Analytical comparisons for the undamaged composite establish that matching US measurements with estimates cannot be obtained, regardless of the chosen model, without the assumption of an interphase layer of modified resin coating the fibers. This coating resin, when in relevant concentration with regard to literature data about fiber coating thickness, typically conserves the epoxy moduli transversally to the fiber orientation, while, in the fiber direction its moduli approach those of the fibers. The comparison of the US measurements on damaged samples to FE calculations assuming progressive one-directional debonding shows that most of the composite stiffness loss can preferentially be due to an initial interphase weakening, while the fiber/matrix debonding seems more likely delayed to long H-ageing times. This is consistent with physical interpretation of damage by water pooling through silane bridges bonding epoxy to glass. The calculations also provide the effective stiffness, at different damage stages, of the “Undamaged Equivalent Inhomogeneity” for this damaged inclusion type.